Firmware Update for PICratchBOX

1. Bootloader Mode
Connect an USB cable while pushing tandem three pads on
right side of 4×4 LED pads.
 
Three LED pads which you push is turned on if PICratchBOX
is launched on bootloader mode.
 
Initial LED Pattern
 
2. Write HEX file
  1. Launch HIDBootloader.
  2. Click "Import Firmware Image" and select HEX file.
  3. Execute "Erase/Program/Verify Device". The console message "Erase/Program/Verify Completed Successfully" is displayed if these process is succeeded.
  4. Shut down HIDBootloader and power on PICnome again.
0 comments on “Firmware Update for PICratchBOX
1 Pings/Trackbacks for "Firmware Update for PICratchBOX"
  1. […] to update firmware of PICratchBOX Tweetドキュメント"PICratchBOXファームウェアの更新方法"を参考にしてください。 Last 5 posts in Controllerpic2osc v1.6.01PICratchBOX f/w for […]

Leave a Reply

Your email address will not be published. Required fields are marked *

*

Language: